By Guy Hanson
For a quick, down-and-dirty setup (I know none of you ever do that), remember that some of the old, manual machining tricks still work on CNC. There are times when our best practices of setting up tools against a master and recording the offsets just don’t happen. When the preset tool breaks or an odd one is needed, remember how it used to be done and you can save time and frustration.
A rule or feeler gauge placed between the tool tip and the work can locate the center of the shaft (in this case, the Y-axis zero point) surprisingly accurately by observing whether it is level and then jogging the axis to make it level.
This example, shown on a Duality lathe, will help to set the Y-axis to zero and can also verify that the lathe bed is parallel with the Y-axis very quickly and is reasonably accurate for most work. Once the Y-axis has been established near the chuck, move the X-axis control to the end of the shaft and check again. The ruler should be level there as well.
Thanks Guy. Your subscription has been extended one issue!
Please do us a tremendous favor and forward this e-mail to your machining friends!
Please do us a tremendous favor and forward this e-mail on to your machining friends!
Are you not a subscriber to DIGITAL MACHINIST? Visit us at www.digitalmachinist.net and request a no-obligation issue, or call and request it at 1-800-447-7367. Tell them you received an e-mail from a friend!
And don’t forget to check out Digital Machinist’s page on Facebook and our Twitter feed!
Your friend thinks you’ll enjoy DM, or you wouldn’t have this e-mail!
We hope you enjoyed this e-mail tip, brought to you by your friends at Digital Machinist.
Get Involved!
Do you enjoy our e-mail tips? Has one of them ever “knocked something loose” in your head? Your tip could be a future e-mail blast from your favorite magazine. Just send your tips to george.bulliss@VPDemandCreation.com. If we use your tip, we will extend your subscription by an issue. We like to see 200 to 300 words, plus an image, if available. Thanks!
We hope you enjoyed this e-mail tip, brought to you by your friends at Digital Machinist, dedicated to precision metalworking.